Chapters0/23 ▾
Chapter 2 · Lesson 1 of 5
Ohm's law, power and what sets a wire's resistance
1 min read
Ohm's law ties voltage (E, in volts), current (I, in amperes) and resistance (R, in ohms) together: E = I × R. Power in watts adds three more forms: P = E × I, P = I² × R, and P = E² / R. Pick the form that uses the two values the question gives you, and you never need a middle step.
- Example 1: a 28-volt motor draws 5 amperes. P = 28 × 5 = 140 watts, and R = 28 / 5 = 5.6 ohms.
- Example 2: a 49-ohm lamp on a 28-volt bus. P = E² / R = 784 / 49 = 16 watts.
A conductor's resistance depends on its material, its temperature, its length and its cross-sectional area. Resistance rises in direct proportion to length and falls as the cross-section grows.
That is why a long wire run needs a larger wire size to keep the voltage drop down, and why aircraft wire tables size conductors by area in circular mils. The current flowing does not change a wire's resistance; it only changes how much heat that resistance makes.
Check yourself
1. Two conductors are of the same material and at the same temperature. Which statement about the resistance of a conductor is correct?
2. A 28-volt DC lamp is rated at 30 watts. Ignoring the change in filament resistance with temperature, what is the lamp's operating resistance?
Facts checked 2026-11-15 · Sources: FAA-S-ACS-1 Aviation Mechanic Airman Certification Standards, FAA Aircraft Handbooks and Manuals (FAA-H-8083-30B Aviation Maintenance Technician Handbook, General)
FAA A&P Mechanic (General) cheat sheet: every key fact on one page →