Quibank app: now on the App Store — free, works offline. Get the app ↗

Chapters0/23 ▾
  1. 1.Regulations, Records & Publications0/5
    1. What an A&P mechanic may do and approve
    2. Major or minor work, approved data and FAA Form 337
    3. Writing maintenance and inspection record entries
    4. Keeping records, AD status and inspection timing
    5. Keeping your mechanic certificate usable
  2. 2.Basic Electricity0/5
    1. Ohm's law, power and what sets a wire's resistance
    2. Series, parallel and series-parallel circuits
    3. Wire ratings, circuit protection and test meters
    4. Aircraft batteries and DC motors
    5. Alternating current, transformers and diodes
  3. 3.Weight & Balance, Math & Physics0/4
    1. Weight and balance terms: datum, empty weight, useful load and MAC
    2. Finding and correcting the center of gravity
    3. Shop mathematics: order of operations, areas, volumes and ratios
    4. Physics for aviation: power, levers, fluids, gases and stress
  4. 4.Materials, Hardware & Drawings0/4
    1. Reading aircraft drawings: lines, sections, tolerances and diagrams
    2. Fluid lines: flares, flareless fittings and flexible hose
    3. Corrosion: how it starts, the forms it takes and how to find it
    4. Aluminum alloys, rivets, bolts, nuts, torque and safety wire
  5. 5.Ground Operation, Servicing & Human Factors0/5
    1. Fire protection on the ramp and during engine starts
    2. Fueling, oxygen servicing and turbine engine starts
    3. Towing, taxi light signals and propeller safety
    4. Inspections and nondestructive testing methods
    5. Human factors: the Dirty Dozen and safety nets
Saved in this browser. Move it to another device →
← Basic Electricity

Chapter 2 · Lesson 5 of 5

Alternating current, transformers and diodes

1 min read

AC meters and system ratings show the effective (rms) value, the one that does the same heating work as an equal direct current. For a sine wave the effective value is 0.707 times the peak, so the peak is 1.414 times the effective value. Example: a 26-volt AC instrument supply peaks at about 26 × 1.414 = 36.8 volts.

  • Inductive reactance, XL = 2 × π × f × L, rises in direct proportion to frequency. Halve the frequency and XL halves. Capacitive reactance does the opposite.
  • Transformer: the voltage ratio equals the turns ratio, and available current changes the opposite way because power out cannot exceed power in. Example: 500 primary turns, 100 secondary turns, 115 volts in gives 23 volts out, with up to five times the current. It works only on AC.
  • Diode: conducts when forward biased and blocks when reverse biased, so it turns AC into pulsating DC. Storing and returning charge describes a capacitor, not a diode.

How the exam asks: it gives the turns or the frequency and asks what happens, so answer in proportions first. A step-up in voltage always comes with a step-down in available current, and any choice where both rise breaks the rule that power out cannot exceed power in.

Check yourself

1. A transformer has 200 turns on the primary and 800 turns on the secondary, and 24 volts AC is applied to the primary. What is the secondary voltage, and what happens to the available current?

2. What property of a semiconductor diode makes it useful as a rectifier?

Facts checked 2026-11-15 · Sources: FAA-S-ACS-1 Aviation Mechanic Airman Certification Standards, FAA Aircraft Handbooks and Manuals (FAA-H-8083-30B Aviation Maintenance Technician Handbook, General)

FAA A&P Mechanic (General) cheat sheet: every key fact on one page →