Quibank app: now on the App Store — free, works offline. Get the app ↗

Chapters0/23 ▾
← Materials, Hardware & Drawings

Chapter 4 · Lesson 4 of 4

Aluminum alloys, rivets, bolts, nuts, torque and safety wire

1 min read

In the four-digit wrought aluminum system, the first digit names the main alloying element: 2xxx copper, 3xxx manganese, 5xxx magnesium, 6xxx magnesium and silicon, 7xxx zinc.

The temper letter follows: O annealed, H strain hardened, T heat treated, and T3 means solution heat treated, cold worked and naturally aged. Rivets of 2017-T and 2024-T age harden at room temperature, so they are kept refrigerated as icebox rivets and driven soon after removal; 2117-T is driven as received.

  • AN bolts: AN6-7 is 6/16 = 3/8 inch in diameter with a 7/8 inch grip, drilled for a cotter pin; AN6-7A has an undrilled shank.
  • Self-locking nuts are not used where the bolt or nut rotates, such as a control surface hinge bolt that turns in its fitting.
  • Torque with a drive-end extension: indicated = desired × L / (L + A). Example: 300 in-lb desired, 12 in wrench, 4 in extension: 300 × 12 / 16 = 225 in-lb on the dial.
  • Safety wire: always new wire, routed so the pull is in the tightening direction, with a 1/4 to 1/2 inch pigtail bent back.

Check yourself

1. A bolt carries the part number AN4-7A. What does that number tell the mechanic?

2. What does the designation 2024-T3 tell a mechanic about the material?

Facts checked 2026-11-15 · Sources: FAA-S-ACS-1 Aviation Mechanic Airman Certification Standards, FAA Aircraft Handbooks and Manuals (FAA-H-8083-30B AMT Handbook, General), FAA AC 43.13-1B Acceptable Methods, Techniques, and Practices: Aircraft Inspection and Repair

FAA A&P Mechanic (General) cheat sheet: every key fact on one page →