Chapters0/23 ▾
Chapter 3 · Lesson 3 of 4
Shop mathematics: order of operations, areas, volumes and ratios
1 min read
Order of operations is parentheses first, then exponents and roots, then multiplication and division from left to right, then addition and subtraction.
Example: (2 + 3²) × 2 − √16 = (2 + 9) × 2 − 4 = 22 − 4 = 18. Scientific notation writes a number as a coefficient from 1 to 10 times a power of ten: 0.000307 = 3.07 × 10⁻⁴, and 52,000 = 5.2 × 10⁴. Moving the decimal point to the right gives a negative exponent.
A ratio compares two quantities in the same units, and gear speeds are inversely proportional to tooth counts, so the smaller gear always turns faster.
| Formula | Original example |
|---|---|
| Trapezoid area = ½ × (side a + side b) × height | Parallel sides 8 and 12 in, height 5 in: 50 sq in |
| Piston displacement = 0.7854 × bore² × stroke × cylinders | 4 in bore, 3.5 in stroke, 4 cylinders: about 175.9 cu in |
| Compression ratio = volume at BDC / volume at TDC | 63 cu in and 9 cu in: 7 to 1 |
| Driven gear rpm = drive rpm × drive teeth / driven teeth | 24-tooth gear at 1,500 rpm driving a 40-tooth gear: 900 rpm |
Check yourself
1. A six-cylinder engine has a cylinder bore of 5.5 in and a stroke of 4.5 in. What is the total piston displacement of the engine?
2. Which is the correct expression of the number 0.00004631 in scientific notation?
Facts checked 2026-11-15 · Sources: FAA-S-ACS-1 Aviation Mechanic Airman Certification Standards, FAA Aircraft Handbooks and Manuals (FAA-H-8083-30B AMT Handbook General; FAA-H-8083-1 Weight and Balance Handbook)
FAA A&P Mechanic (General) cheat sheet: every key fact on one page →