Chapters0/23 ▾
Chapter 3 · Lesson 1 of 4
Weight and balance terms: datum, empty weight, useful load and MAC
1 min read
The datum is an imaginary vertical plane chosen by the manufacturer, not measured by the mechanic.
It can sit at the nose, the firewall, the wing leading edge or even ahead of the aircraft, and its location, the CG range and the leveling means are published in the Type Certificate Data Sheet or Aircraft Specifications. Every arm is a distance from that datum, positive aft and negative forward.
- Empty weight: airframe, powerplant, installed equipment, fixed ballast, hydraulic fluid, and unusable fuel and oil. Never usable fuel, crew, payload or temporary ballast.
- Useful load = maximum allowable gross weight minus empty weight. Example: 2,550 lb minus 1,620 lb = 930 lb.
- Percent MAC = (CG minus LEMAC) / MAC × 100. Example: LEMAC at +60.0, MAC 64.0 in, CG at +73.6 gives 13.6 / 64.0 × 100 = 21.25 percent MAC.
The exam also asks why limits matter. A CG aft of the rear limit shortens the tail's arm and reduces longitudinal stability, and stall recovery may become impossible.
Nose heaviness, higher stall speed and heavy elevator forces are signs of a CG too far forward, the opposite problem. For useful load, the wrong choices usually add the two weights or simply repeat one of them.
Check yourself
1. On an aircraft weight and balance problem, where does a mechanic find the location of the datum for a particular aircraft?
2. Which combination of items is included in the licensed empty weight of an aircraft?
Facts checked 2026-11-15 · Sources: FAA-S-ACS-1 Aviation Mechanic Airman Certification Standards, FAA Aircraft Handbooks and Manuals (FAA-H-8083-30B AMT Handbook General; FAA-H-8083-1 Weight and Balance Handbook)
FAA A&P Mechanic (General) cheat sheet: every key fact on one page →