Quibank app: now on the App Store — free, works offline. Get the app ↗

Chapters0/23 ▾
← Ground Operation, Servicing & Human Factors

Chapter 5 · Lesson 4 of 5

Inspections and nondestructive testing methods

1 min read

Annual and 100-hour inspections are done with a checklist that includes at least the scope and detail of part 43 appendix D, whether it is the manufacturer's list or your own, because the most likely inspection failure is leaving something out.

A special inspection follows any suspected hard landing, even at or below maximum landing weight, and wrinkled wing skin is the easiest sign of excessive load to spot. The manufacturer's data, not your judgment, sets what is inspected.

MethodWorks onFinds
VisualAny clean surfaceSurface defects, with light at a low angle and a 10-power magnifier to confirm
PenetrantAlmost any nonporous materialOnly flaws open to the surface
Magnetic particleFerromagnetic parts onlyFlaws crossing the field; circular magnetization for lengthwise cracks; demagnetize after
Eddy currentConductive materialsSurface and near-surface flaws, often through paint
RadiographyParts the radiation can pass through, with radiation safety controlsInternal flaws, but not how deep they lie

Each method has a mechanism that sets its limits. Penetrant is drawn into an open crack by capillary action and blotted back out by the developer, so a porous part holds penetrant everywhere and hides real defects.

Eddy current reads a change in impedance and needs a reference standard of the same material. Visual inspection needs a clean surface, since dirt and old sealant hide cracks.

Check yourself

1. A steel landing gear part is being magnetic particle inspected for cracks that run parallel to its long axis. Which statement is correct?

2. Which statement correctly compares eddy current inspection with radiographic (x-ray) inspection?

Facts checked 2026-11-15 · Sources: FAA-S-ACS-1 Aviation Mechanic Airman Certification Standards, FAA Aircraft Handbooks and Manuals (FAA-H-8083-30B AMT Handbook, General), 14 CFR Part 43: Maintenance, Preventive Maintenance, Rebuilding, and Alteration

FAA A&P Mechanic (General) cheat sheet: every key fact on one page →