Quibank app: now on the App Store — free, works offline. Get the app ↗

Chapters0/23 ▾
← Materials, Hardware & Drawings

Chapter 4 · Lesson 3 of 4

Corrosion: how it starts, the forms it takes and how to find it

1 min read

Electrochemical corrosion is a small battery on the metal. It needs an anodic area, a cathodic area, an electrolyte touching both, and a conductive path between them. The anode gives up electrons and is destroyed, and removing any one condition, usually the electrolyte by sealing, draining or coating, stops the attack.

Example: an aluminum bracket bolted to a carbon-fiber panel in a wet bay corrodes, because aluminum is anodic to graphite; a sealant, primer or fiberglass ply between them breaks the couple.

  • Concentration cell (crevice): one metal only, under tape, dirt or in a joint, where oxygen or ion levels differ.
  • Filiform: wormlike lines under paint, at about 78 to 90 percent relative humidity; prevented by storage below 70 percent.
  • Intergranular: along grain boundaries, often after improper heat treatment of alloys such as 7075; may show nothing at the surface, so eddy current or ultrasonic inspection is used.
  • Exfoliation: advanced intergranular attack in extrusions, where swelling corrosion products lift the metal in leaves.

On Alclad, remove corrosion lightly with aluminum wool or a pad kept only for aluminum, so the pure aluminum cladding stays. Steel wool and steel brushes are prohibited because embedded steel starts new dissimilar-metal corrosion.

Eddy current works on any conductive metal and finds surface and near-surface flaws, while dye penetrant shows only flaws open to the surface and magnetic particle works only on ferromagnetic parts.

Check yourself

1. Electrochemical corrosion cannot take place unless four conditions exist at the same time. Which set is correct?

2. An aluminum alloy bracket is bolted directly against a graphite/epoxy panel and the joint is wetted by condensation. Which member corrodes, and why?

Facts checked 2026-11-15 · Sources: FAA-S-ACS-1 Aviation Mechanic Airman Certification Standards, FAA Aircraft Handbooks and Manuals (FAA-H-8083-30B AMT Handbook, General), FAA AC 43.13-1B Acceptable Methods, Techniques, and Practices: Aircraft Inspection and Repair

FAA A&P Mechanic (General) cheat sheet: every key fact on one page →