Chapters0/23 ▾
Chapter 4 · Lesson 1 of 4
Reading aircraft drawings: lines, sections, tolerances and diagrams
1 min read
| Line | How it is drawn | Meaning |
|---|---|---|
| Hidden | Short dashes, medium weight | An edge you cannot see from this view |
| Center | Thin long and short dashes | Center of a hole or symmetric part |
| Phantom | One long dash, two short dashes | Alternate position or adjacent part |
| Break | Ruled line with freehand zigzags | Part shortened on the drawing |
A removed section is drawn away from the main view and keyed to a lettered cutting-plane line, so it can be enlarged to show a small detail; a revolved section is drawn right on the view.
For tolerances, a dimension that carries its own limits governs, and a blanket note in the title block covers only dimensions without limits. Tolerance is the sum of the plus and minus allowances. Example: 1.250 +0.004 −0.001 inch has a tolerance of 0.005 inch, so the part is good from 1.249 to 1.254 inch.
Diagrams each do one job. A schematic shows how a system works and how parts relate, ignoring their size and location. An installation diagram shows where parts are located in the aircraft, a block diagram simplifies a system into rectangles, and a wiring diagram carries the coded electrical circuits.
When a question says "shows how the system works," the answer is the schematic, because that is the drawing used for troubleshooting and training.
Check yourself
1. The title block of a drawing states 'All tolerances ±1/32 inch unless otherwise specified.' One hole on the same drawing is dimensioned 2.000 +0.005 −0.002 inch. Which value governs that hole, and what is the tolerance on it?
2. Which statement about a schematic diagram of an aircraft system is true?
Facts checked 2026-11-15 · Sources: FAA-S-ACS-1 Aviation Mechanic Airman Certification Standards, FAA Aircraft Handbooks and Manuals (FAA-H-8083-30B AMT Handbook, General), FAA AC 43.13-1B Acceptable Methods, Techniques, and Practices: Aircraft Inspection and Repair
FAA A&P Mechanic (General) cheat sheet: every key fact on one page →