Chapters0/23 ▾
Chapter 5 · Lesson 2 of 5
Fueling, oxygen servicing and turbine engine starts
1 min read
Avgas is dyed so the grade can be checked by eye: grade 80 is red, 100 is green, 100LL is blue, and turbine fuel is clear to straw colored. Liquid fuel does not burn, its vapor does, and the spark in a fueling job is static built up by fuel flowing through the hose.
So every item is brought to the same electrical potential before the filler cap opens: ground the aircraft, ground the truck, bond the truck to the aircraft, then bond the nozzle, and remove the leads in reverse order. Leads go to bare metal or marked points, never to an exhaust stack or a propeller.
- Oxygen servicing: two people, everything free of oil and grease, slow filling to limit heat of compression, and only aviator's breathing oxygen, because medical oxygen contains water that can freeze at altitude.
- Hot start: ITT or EGT climbs past the limit during a turbine start because the fuel/air ratio is too rich. Shut off the fuel and abort.
- Hung start: the engine lights off but stabilizes at low rpm and never accelerates, a different fault from a hot start.
Why oxygen needs such care: oxygen itself does not burn, but combustibles ignite far more easily and burn hotter in an oxygen-rich atmosphere, and oil or grease in contact with oxygen can explode from compression or impact. That is why oxygen servicing is never done at the same time as fueling.
Check yourself
1. Select the proper procedure for making the electrical connections when refueling an aircraft from a fuel truck.
2. Which practice is required when servicing an aircraft gaseous oxygen system?
Facts checked 2026-11-15 · Sources: FAA-S-ACS-1 Aviation Mechanic Airman Certification Standards, FAA Aircraft Handbooks and Manuals (FAA-H-8083-30B AMT Handbook, General), 14 CFR Part 43: Maintenance, Preventive Maintenance, Rebuilding, and Alteration
FAA A&P Mechanic (General) cheat sheet: every key fact on one page →