Quibank app: now on the App Store — free, works offline. Get the app ↗

Chapters0/23 ▾
← Basic Electricity

Chapter 2 · Lesson 4 of 5

Aircraft batteries and DC motors

1 min read

The two common battery types behave in opposite ways, and the exam tests exactly that contrast. In a lead-acid cell the sulfuric acid is used up as the battery discharges and water forms, so the specific gravity of the electrolyte drops along with the state of charge.

A hydrometer reading therefore tells you the charge, but only if it is taken before any water is added, because new water dilutes the sample.

In a nickel-cadmium cell the potassium hydroxide electrolyte takes no lasting part in the reaction, so its specific gravity stays nearly constant and cannot show the charge. Its level does change: it falls during discharge and is highest at the end of a charge. Add distilled water only when the battery is fully charged, or the cell will overflow later.

DC motors appear in the same section. A series-wound motor has its field in series with the armature, so both carry the same current. At standstill there is no counter EMF, the current is at its maximum, and torque is greatest.

That is why series motors drive engine starters and landing gear actuators. Example: a question describing a heavy load that must be moved from rest points to the series-wound motor, not the shunt or compound type.

Check yourself

1. How does the electrolyte of a nickel-cadmium battery behave compared with that of a lead-acid battery, and when should distilled water be added to the nickel-cadmium battery?

2. A lead-acid aircraft battery is being checked with a hydrometer. Which statement about the procedure and the readings is correct?

Facts checked 2026-11-15 · Sources: FAA-S-ACS-1 Aviation Mechanic Airman Certification Standards, FAA Aircraft Handbooks and Manuals (FAA-H-8083-30B Aviation Maintenance Technician Handbook, General)

FAA A&P Mechanic (General) cheat sheet: every key fact on one page →