Chapters0/26 ▾
Study guide · Chapter 4 of 7
A4 — Suspension & Steering Study Guide — ASE Automotive Technician
28 free practice questions
The A4 Suspension and Steering certification test has 40 scored questions plus 10 unscored research questions in 60 minutes. Steering systems and suspension systems are 12 questions each, wheel alignment is 11, and wheels and tires are 5. Expect pull, wander, noise, vibration and tire-wear complaints that you trace to one angle or one worn part.
Key takeaways
- A vehicle pulls toward the side with more positive camber and toward the side with less positive caster.
- A feathered, saw-tooth tread edge means toe is wrong; camber wears one shoulder, and caster causes no tire wear.
- On a hydraulic system, if pressure reaches specification with the shutoff valve briefly closed but is low at the stops, the steering gear is leaking internally.
- A wheel bearing growl gets louder when the turn loads it, so noise in a left turn points to the right-side bearing.
- After any toe change, relearn the steering angle sensor and aim any forward camera as the manufacturer specifies.
Lessons in this chapter
4 short lessons · 4 min read
- 1Power steering systems and steering gears1 min
- 2Suspension inspection and service1 min
- 3Wheel alignment angles and pull diagnosis1 min
- 4Wheels, tires, balance and TPMS1 min
Facts checked 2026-11-15 · Sources: ASE: Official Automobile Study Guide (A4 Suspension and Steering test specifications and task list), ASE: Automobile and Light Truck (A1-A9) tests, eCFR: 49 CFR 571.138, FMVSS No. 138 Tire pressure monitoring systems
ASE Automotive Technician cheat sheet: every key fact on one page →Next chapter: A8 — Engine Performance →Practice questions written to the ASE Automobile & Light Truck (A-series) task lists and standard automotive service principles. ASE is a mark of the National Institute for Automotive Service Excellence; this site is not affiliated with or endorsed by ASE. Always follow the vehicle manufacturer's service information for specifications and procedures on a real repair. About the ASE tests →