Chapters0/26 ▾
Chapter 4 · Lesson 2 of 4
Suspension inspection and service
1 min read
Springs carry the weight and set ride height; shocks only damp motion, and a stabilizer bar only controls roll. So a vehicle that sits below specified ride height at all four corners and dives hard under braking has sagged springs, not worn shocks.
- Ball joints: the joint on the arm that holds the spring carries the load. With the spring on the lower arm, support the lower arm near the joint so the stand, not the joint, holds spring force, then measure play.
- Bonded rubber bushings twist instead of sliding, so give the through-bolts final torque with the suspension at curb height, never hanging at full rebound.
- Leaf springs: a broken center bolt or collapsed shackle bushing lets the axle shift out of square, which shows up as a bad thrust angle with perfect front angles.
- The dry park test, rocking the steering wheel with the tires on the ground, finds lost motion in tie rod ends, the idler arm and the gear that a raised-wheel check can hide.
Example: a front growl at steady speed gets louder in a gentle right turn and quieter in a left turn. A right turn shifts weight onto the left side, so the left front wheel bearing is the likely source.
Check yourself
1. A growl from the front of a vehicle gets louder during a gentle left turn at steady speed and quieter in a right turn. What does this most likely indicate?
2. A vehicle dives heavily under braking and measured ride height is below the value given in the service information at all four corners. What is the most likely cause?
Facts checked 2026-11-15 · Sources: ASE: Official Automobile Study Guide (A4 Suspension and Steering test specifications and task list), ASE: Automobile and Light Truck (A1-A9) tests, eCFR: 49 CFR 571.138, FMVSS No. 138 Tire pressure monitoring systems
ASE Automotive Technician cheat sheet: every key fact on one page →