Chapters0/26 ▾
Chapter 3 · Lesson 5 of 5
Body electrical, airbags and networked modules
1 min read
Body electrical is the largest A6 area, and its questions are logic puzzles: decide what has been proven good, then look only at what is left.
- Power windows: a window that works both ways from its own switch proves the motor and its wiring good. If the master switch moves it only one way, the fault is in the master switch contacts for the other direction.
- Several devices in one door that fail together and change as the door moves point to a broken wire in the door jamb harness.
- Airbag, horn and steering wheel buttons all dead after column work point to a torn clockspring. When servicing an airbag, follow the disable procedure, wait the specified time, carry the module with the trim cover away from you and set it face up.
- A gauge that reads wrong while the scan tool shows a correct sensor value means the sensor is fine; the fault is in the cluster or the network message path.
- Normal cranking, no injector pulse and a flashing security lamp point to an immobilizer that did not recognize the key.
Example: on a rear defogger, a grid line with the meter's negative lead grounded should fall smoothly from about 12 V at the feed end to about 0 V at the ground end. If one line holds 12 V for a third of its length and then drops straight to 0 V, the line is broken at that spot.
Check yourself
1. All of these are correct practices when removing a driver's airbag module EXCEPT:
2. A temperature gauge reads at the top of its scale while the engine runs at normal temperature, and a scan tool shows the coolant temperature PID at 195 degrees F with no driveability complaint. What should the technician suspect?
Facts checked 2026-11-15 · Sources: ASE: Official Automobile Study Guide (A6 Electrical/Electronic Systems test specifications and task list), ASE: Automobile and Light Truck (A1-A9) tests
ASE Automotive Technician cheat sheet: every key fact on one page →