Quibank app: now on the App Store — free, works offline. Get the app ↗

Chapters0/26 ▾
← A1 — Engine Repair

Chapter 1 · Lesson 4 of 4

Cylinder head, valve train and block measurements

1 min read

Many A1 questions ask which tool measures which dimension, or which step makes a reading valid. The answer is always compared with the manufacturer's specification, so learn the method rather than numbers.

CheckCorrect method
Head warpageStraightedge and feeler gauge, lengthwise and across both diagonals
Bearing clearancePlastigage on a dry journal, cap torqued, crank not turned, width read on the wrapper scale
Bore taper and out-of-roundDial bore gauge: top versus bottom of ring travel is taper; two readings 90° apart at one depth is out-of-round
Crankshaft end playDial indicator on the block, tip on the crank nose, crank pried fully each way

Torque-to-yield head bolts are stretched on purpose, so they are replaced, never reused or re-torqued, and they are tightened in stages from the center outward and then turned a set angle.

On solid lifters, lash set too tight holds the exhaust valve off its seat, so it cannot cool and burns. When a timing belt breaks on an interference engine, expect bent valves and inspect the heads before fitting a new belt.

Check yourself

1. Plastigage is being used to check a connecting rod bearing clearance. Which procedure produces a valid reading?

2. A cylinder head is being installed on an engine that uses torque-to-yield head bolts. Which statement describes correct practice?

Facts checked 2026-11-15 · Sources: ASE: Official Automobile Study Guide (A1 Engine Repair test specifications and task list), ASE: Automobile and Light Truck (A1-A9) tests

ASE Automotive Technician cheat sheet: every key fact on one page →