Chapters0/26 ▾
Chapter 1 · Lesson 1 of 4
Compression and cylinder leakage tests
1 min read
A cranking compression test tells you whether each cylinder can seal, and the pattern of readings tells you why it cannot. One low cylinder points to a part only that cylinder uses: its rings, its valves, or its own section of head gasket.
Two low cylinders side by side point to the head gasket land between them, especially when the engine also loses coolant with no outside leak and puffs white smoke. All cylinders low by about the same amount points to something every cylinder shares, such as valve timing after a timing chain or belt jumps.
Example: readings of 172, 168, 96 and 170 psi. Squirt a little oil into the third cylinder and retest.
If it climbs to about 158 psi, the oil sealed the ring gap, so the rings or the cylinder wall are worn. If it barely moves, oil cannot seal a valve or gasket, and a cylinder leakage test is the next step.
| Where the air escapes (piston at TDC, compression stroke) | Leak path |
|---|---|
| Tailpipe | Exhaust valve not seating |
| Throttle body or intake | Intake valve not seating |
| Oil fill opening | Rings or cylinder wall |
| Bubbles in the coolant | Head gasket or a cracked head or block |
Check yourself
1. During a cranking compression test one cylinder reads far below the others. A small amount of engine oil is squirted into that cylinder and the test is repeated; the reading rises sharply. What does this result indicate?
2. A cranking compression test shows all cylinders low but within a few points of each other. The engine starts and idles but has almost no power. Which cause best fits this pattern?
Facts checked 2026-11-15 · Sources: ASE: Official Automobile Study Guide (A1 Engine Repair test specifications and task list), ASE: Automobile and Light Truck (A1-A9) tests
ASE Automotive Technician cheat sheet: every key fact on one page →