Quibank app: now on the App Store — free, works offline. Get the app ↗

Chapters0/26 ▾
← A6 — Electrical / Electronic Systems

Chapter 3 · Lesson 4 of 5

Lighting system diagnosis

1 min read

Lighting questions reward one habit: when several lamps act up together, look for what they share. Two headlamps that are both dim and yellow, with new bulbs and good charging voltage, point to resistance in the feed or ground they have in common.

A voltage-drop test on that shared path confirms it. Example: with the headlamps on, the battery reads 12.6 V but only 11.4 V reaches across one headlamp's terminals, so 1.2 V is being lost in its feed and ground, far more than the few tenths a lamp circuit should lose.

Measure the feed side and the ground side separately to see which one holds the resistance. One lamp acting up alone points to that lamp's own bulb, socket or wiring.

A lost shared ground causes backfeed. Example: with the left turn signal on, the left tail lamp and left stop lamp glow faintly and blink in time with it, while the right side works normally.

Current from the turn filament cannot reach ground directly, so it returns through the other filaments on that ground, lighting them dimly. Repair the corroded or open ground for that lamp group.

Check yourself

1. Both headlamps are dim and yellowish at idle and at road speed. The bulbs are new, and the battery and charging voltage test good. What is the MOST likely cause?

2. Incandescent turn signal bulbs have been replaced with LED units. Both sides now flash rapidly and the driver information display shows a lamp outage message. What explains this and corrects it?

Facts checked 2026-11-15 · Sources: ASE: Official Automobile Study Guide (A6 Electrical/Electronic Systems test specifications and task list), ASE: Automobile and Light Truck (A1-A9) tests

ASE Automotive Technician cheat sheet: every key fact on one page →