Quibank app: now on the App Store — free, works offline. Get the app ↗

Chapters0/26 ▾
← A5 — Brakes

Chapter 2 · Lesson 1 of 4

Master cylinder, brake lines and brake fluid

1 min read

Pedal complaints are sorted by whether fluid leaves the system. A firm pedal that slowly sinks while you hold it at a stop, with no outside leak and a normal reservoir level, means fluid is slipping past the master cylinder piston cups and returning to the reservoir.

Fluid never leaves the system, so the level does not drop. A spongy pedal suggests air, and a low pedal that pumps up suggests too much clearance at the wheels.

One wheel that drags and runs hot points to pressure trapped at that wheel. If opening the caliper bleeder releases a spurt of fluid and the wheel then turns freely, the flexible hose has collapsed inside and is acting like a one-way valve. A master cylinder fault would drag all four wheels.

  • Lines: replace a rusted section with steel brake tubing, or copper-nickel tubing approved for brake use (SAE J1650), formed with double or ISO bubble flares. Plain copper, soft aluminum, single flares, compression fittings and brazed patches can burst.
  • Fluid: DOT 3, DOT 4 and DOT 5.1 are glycol based and absorb water, which lowers the boiling point. DOT 4 has a higher specified dry boiling point than DOT 3. DOT 5 is silicone and must never be mixed with glycol fluid.
  • Pour fluid from a sealed container and never reuse fluid that has been drained.

Check yourself

1. A vehicle has a firm brake pedal that slowly sinks toward the floor while steady pressure is held at a stop. The fluid level is normal and no external leaks are found anywhere in the system. What is the most likely cause?

2. A section of steel brake line is badly rusted and is leaking. What is the correct repair?

Facts checked 2026-11-15 · Sources: ASE: Official Automobile Study Guide (A5 Brakes test specifications and task list), ASE: Automobile and Light Truck (A1-A9) tests

ASE Automotive Technician cheat sheet: every key fact on one page →