Quibank app: now on the App Store — free, works offline. Get the app ↗

Chapters0/26 ▾
← A8 — Engine Performance

Chapter 5 · Lesson 2 of 4

Engine mechanical and ignition testing

1 min read

Rule out the engine's mechanical condition before chasing electronics. A vacuum gauge that reads normal at idle but slowly falls while the engine is held at about 2,500 rpm points to an exhaust restriction such as a plugged converter.

On a compression test, a low cylinder that rises sharply with a little oil added has worn rings; a head gasket leak between two cylinders would drop both neighbors. Variable valve timing phasers are moved by engine oil, so sludge or the wrong viscosity can set cam timing codes.

  • Coil swap: move the suspect coil to another cylinder. If the misfire follows the coil, replace it; if it stays, test that cylinder's plug, injector and compression.
  • Secondary waveform: a tall firing line with a short spark line means high resistance, such as a wide gap or an open plug wire. A fouled plug or rich mixture shows the opposite.
  • Crank, no spark, no injector pulse and 0 rpm on the scan tool while cranking: the crankshaft position signal is missing. A lost camshaft signal alone usually causes only a long crank.
  • Spark knock comes from too much heat or pressure: over-advanced timing for the fuel, carbon deposits, or an EGR valve that does not flow.

Example: a coil-on-plug engine sets a cylinder 3 misfire code. You move the cylinder 3 coil to cylinder 6, clear the code and road test.

The new code is for cylinder 6, so the misfire followed the coil and the coil is the part to replace. Had the code stayed on cylinder 3, the coil would be cleared and the plug, injector and compression on cylinder 3 would be next.

Check yourself

1. A cylinder 2 misfire code is stored on a coil-on-plug engine. The technician swaps the cylinder 2 coil with the cylinder 5 coil and clears the code. After a road test the cylinder 2 misfire code returns. What should the technician do next?

2. Cranking compression on a four-cylinder engine reads 190, 185, 60 and 188 psi against a specification of 190 psi. A few drops of oil added to cylinder 3 raise its reading to 175 psi. Technician A says the wet-test result points to worn rings or a worn cylinder wall. Technician B says the readings point to a head gasket leaking between cylinders 3 and 4. Who is right?

Facts checked 2026-11-15 · Sources: ASE: Official Automobile Study Guide (A8 Engine Performance test specifications and task list), ASE: Automobile and Light Truck (A1-A9) tests

ASE Automotive Technician cheat sheet: every key fact on one page →