Chapters0/26 ▾
Chapter 4 · Lesson 1 of 4
Power steering systems and steering gears
1 min read
Hydraulic power steering is tested with a pressure gauge and shutoff valve between the pump and the gear. Closing the valve for no longer than the few seconds the manufacturer allows dead-heads the pump.
If pressure then reaches specification but is low when the wheel is held at each stop, the pump is fine and the gear is leaking internally past its seals. Foamy, milky fluid with a whine means air is being drawn in on the suction side: the reservoir feed hose, its clamp, a low level or the pump inlet seal.
- Electric power steering has no pump, hoses or fluid. Diagnose lost assist by reading codes with a scan tool, then testing the motor, torque sensor and their power, ground and signal circuits.
- Recirculating-ball gear: set worm bearing preload first, then set sector lash with the gear centered, where engagement is tightest.
- Before removing a steering wheel with an airbag, disable the system, wait the specified time, keep the clockspring centered, and never put an ohmmeter on the inflator circuit.
Example: a hydraulic system makes 1,450 psi when the valve is briefly closed, matching its specification, but only about half that at full lock. The pump passed, so replacing it would not help; the gear is the part to repair.
Check yourself
1. A vehicle with hydraulic power steering has heavy effort at both stops. A gauge with a shutoff valve is installed between the pump and the gear. With the engine warm at idle, pressure is low when the wheel is held at each stop, but rises to the value listed in the service information when the valve is briefly closed. What does this indicate?
2. A vehicle with a column-mounted electric power steering system has lost assist and the steering warning lamp is on. Which approach is correct for diagnosing it?
Facts checked 2026-11-15 · Sources: ASE: Official Automobile Study Guide (A4 Suspension and Steering test specifications and task list), ASE: Automobile and Light Truck (A1-A9) tests, eCFR: 49 CFR 571.138, FMVSS No. 138 Tire pressure monitoring systems
ASE Automotive Technician cheat sheet: every key fact on one page →