Quibank app: now on the App Store — free, works offline. Get the app ↗

Chapters0/26 ▾
← A6 — Electrical / Electronic Systems

Chapter 3 · Lesson 1 of 5

Ohm's law, series and parallel circuits

1 min read

Ohm's law ties the three quantities together: voltage equals current times resistance. In a series circuit the resistances add, the same current flows through every part, and each part's voltage drop is that current times its own resistance.

In a parallel circuit every branch sees full source voltage, branch currents add, and total resistance is always less than the smallest branch.

  • Series example: 12 V across 1, 3 and 2 ohms. Total resistance is 6 ohms, so current is 2 A everywhere. The drops are 2 V, 6 V and 4 V, which add back up to 12 V, and the 3 ohm part drops the most.
  • Parallel example: 12 V across a 4 ohm branch and a 6 ohm branch. The branches draw 3 A and 2 A, so the total is 5 A and total resistance is 12 divided by 5, or 2.4 ohms, smaller than either branch.

A voltmeter placed across a component reads the voltage lost in that component, not the voltage supplied to it. A good closed switch drops only about a tenth of a volt.

If a dim lamp's switch shows 3.1 V across it with 12.5 V at the battery, the lamps are getting only about 9.4 V, and the switch contacts are the fault.

Check yourself

1. A series circuit has a 12 V source and three resistors of 2 ohms, 4 ohms, and 6 ohms. Which statement about this circuit is correct?

2. Three lamps are connected in parallel across a 12 V supply and draw 2 A, 3 A, and 1 A. A fourth lamp is added in parallel with them. What happens to the circuit totals?

Facts checked 2026-11-15 · Sources: ASE: Official Automobile Study Guide (A6 Electrical/Electronic Systems test specifications and task list), ASE: Automobile and Light Truck (A1-A9) tests

ASE Automotive Technician cheat sheet: every key fact on one page →