Quibank app: now on the App Store — free, works offline. Get the app ↗

Chapters0/26 ▾
← A7 — Heating & Air Conditioning

Chapter 6 · Lesson 5 of 5

Automatic climate sensors, weak heat and coolant electrolysis

1 min read

Automatic temperature control sensors are typically NTC thermistors: resistance falls as temperature rises. An open circuit therefore reads as extremely cold, and a short reads as extremely hot.

If an open duct sensor tells the module the discharge air is freezing, the module drives the blend door to full heat and the blower to high, even at a 72°F setting.

A sun load sensor is different: it responds to light, so indoors it can set a code while working perfectly. Shine a bright light on it and recheck before replacing anything.

Heater complaints often start in the cooling system. A working thermostat stays closed during warm-up, so the upper radiator hose warms slowly and the lower hose stays cool. If both hoses warm together from a cold start, the thermostat is stuck open or missing and the coolant never gets hot enough for good heat.

Stray current is the other A7 cooling test: with the meter negative on the battery negative post and the positive lead in the coolant, not touching metal, common test procedures treat a reading above about 0.3 V as confirmed electrical leakage that can eat the heater core and radiator; some screen lower, at about 0.1 V. After the bad ground is fixed, the target is near 0 V.

Check yourself

1. A customer complains of weak heat. While the engine warms up from a cold start, the upper and lower radiator hoses get warm at the same rate. What does this indicate?

2. To test for electrolysis, the DVM negative lead is placed on the battery negative post and the positive lead in the coolant, not touching metal. Above roughly what reading do common test procedures confirm stray current in the coolant?

Facts checked 2026-11-16 · Sources: ASE: Official Automobile Study Guide (A7 Heating and Air Conditioning test specifications and task list), EPA: Section 609 Technician Training and Certification Programs, EPA: Unique Fittings and Label Colors (MVAC refrigerants)

ASE Automotive Technician cheat sheet: every key fact on one page →