Quibank app: now on the App Store — free, works offline. Get the app ↗

Chapters0/26 ▾
← A8 — Engine Performance

Chapter 5 · Lesson 4 of 4

Emissions controls and engine sensors

1 min read

Emissions questions ask you to find the real failure, not the part that set the code. A small evaporative leak code only says the sealed system lost its test pressure too fast; a smoke test finds the actual leak point.

Pinching the PCV hose at idle should change idle speed or quality, so no change at all means the valve or its passage is plugged.

A catalyst efficiency code with a downstream oxygen sensor switching almost like the upstream one means the converter is no longer storing oxygen, but converters are usually victims: find the misfire, rich running or oil and coolant burning that killed it first.

Sensor logic: when several unrelated sensors, such as manifold pressure, throttle position and EGR position, read zero at the same moment while temperature sensors look normal, suspect the shared 5 V reference circuit shorted to ground rather than three failed sensors.

Check yourself

1. How does a wide-band air/fuel ratio sensor differ from a conventional zirconia oxygen sensor?

2. Several codes set at the same time. Scan data shows manifold absolute pressure at 0.1 volt, throttle position at 0 percent and exhaust gas recirculation position at 0 volt, while coolant and intake air temperature read plausible values. What is the most likely cause?

Facts checked 2026-11-15 · Sources: ASE: Official Automobile Study Guide (A8 Engine Performance test specifications and task list), ASE: Automobile and Light Truck (A1-A9) tests

ASE Automotive Technician cheat sheet: every key fact on one page →