Chapters0/26 ▾
Chapter 2 · Lesson 2 of 4
Brake valves, power boosters and electric parking brakes
1 min read
Front-disc, rear-drum systems use valves to balance the two ends. Each has one job, and the exam swaps their jobs in the wrong answers.
| Valve | What it does | Exam clue |
|---|---|---|
| Metering (hold-off) | Delays front pressure until the rear shoes overcome their return springs | No fluid at the front bleeders during pressure bleeding: hold the valve open |
| Proportioning | Limits rear pressure above a split point | Rear wheels lock first in a hard stop |
| Residual check | Keeps a few psi in a drum circuit so wheel cylinder cups stay sealed | Never used in a disc circuit, where it would cause drag |
Vacuum booster check: with the engine off, pump the pedal to use up reserve vacuum, hold firm pressure, and start the engine. A slight pedal drop means the booster works.
Hydro-boost gets its assist from the power steering pump, so a hard pedal on that system starts with power steering fluid level, the belt and the hoses, not with vacuum tests.
On an electric parking brake with motor-on-caliper actuators, put the caliper in service mode with a scan tool before retracting the piston; a C-clamp alone damages the screw drive.
Example: a pickup with hydro-boost has a hard pedal, and you find the power steering belt glazed and slipping. Replace or adjust the belt and recheck the pedal before you suspect the booster, because the booster can only assist as well as the pump feeds it.
Check yourself
1. During a hard stop on dry pavement the rear wheels lock before the fronts on a vehicle without ABS. Which condition would most likely cause this?
2. A vehicle with hydro-boost hydraulic power assist has a hard brake pedal and poor assist. Which check should be made first?
Facts checked 2026-11-15 · Sources: ASE: Official Automobile Study Guide (A5 Brakes test specifications and task list), ASE: Automobile and Light Truck (A1-A9) tests
ASE Automotive Technician cheat sheet: every key fact on one page →