Chapters0/26 ▾
Chapter 4 · Lesson 4 of 4
Wheels, tires, balance and TPMS
1 min read
Vibration questions turn on the direction of the shake. Static imbalance is one heavy spot in the wheel's center plane, which throws the assembly up once per turn and is felt as vertical hop or tramp. Dynamic imbalance has heavy spots offset to opposite sides, which wobbles the assembly side to side and is felt as shimmy.
If a correctly balanced assembly goes out of balance again within a few hundred miles, check the hub and wheel mounting faces for rust or damage and measure radial and lateral runout before adding more weight; matching the tire's position on the rim can bring runout back into range.
| Tire wear pattern | Angle that causes it |
|---|---|
| Feathered, saw-tooth edges across the ribs | Toe |
| One shoulder worn smooth | Camber |
| No wear pattern | Caster |
Tire pressure monitoring comes in two kinds. A direct system has a pressure sensor at each wheel that reports by radio with its own ID, so many vehicles need a relearn after a sensor is replaced or the tires are rotated.
An indirect system has no wheel sensors; it infers a low tire from ABS wheel speed differences and is reset after the tires are set to the placard pressure.
Federal rules (FMVSS No. 138) require the low-pressure lamp to light within 20 minutes once a tire falls 25 percent below the placard cold pressure, so a 36 psi placard means a warning by about 27 psi. A lamp that flashes for 60 to 90 seconds at startup and then stays on signals a system malfunction, not a low tire.
Check yourself
1. Technician A says a direct tire pressure monitoring system uses a pressure sensor at each wheel and that many vehicles need a relearn after sensors are replaced or tires are rotated. Technician B says an indirect system measures pressure with a sensor inside each valve stem and never has to be reset. Who is correct?
2. A wheel assembly is balanced correctly, but the highway speed vibration returns within a few hundred miles and the assembly reads out of balance again. What should be inspected?
Facts checked 2026-11-15 · Sources: ASE: Official Automobile Study Guide (A4 Suspension and Steering test specifications and task list), ASE: Automobile and Light Truck (A1-A9) tests, eCFR: 49 CFR 571.138, FMVSS No. 138 Tire pressure monitoring systems
ASE Automotive Technician cheat sheet: every key fact on one page →