Quibank app: now on the App Store — free, works offline. Get the app ↗

Chapters0/26 ▾
← A5 — Brakes

Chapter 2 · Lesson 3 of 4

Drum and disc brake service

1 min read

Drum brakes: a low pedal that pumps up and improves after several hard stops in reverse points to self-adjusters that are not working, because duo-servo adjusters are worked by reverse stops. Never blow brake assemblies clean with compressed air, since it puts brake dust into your breathing zone; use wet cleaning or an enclosed HEPA vacuum.

Disc brakes: pulsation felt in the pedal, with steering wheel shudder from the front rotors, comes from rotor thickness variation, which you measure with a micrometer at several points around the rotor.

Lateral runout, read with a dial indicator on the rotor face through one full turn, is what slowly wears a rotor into thickness variation; clean the hub face, index the rotor and recheck.

On a single-piston floating caliper the piston pushes only the inboard pad, so an inboard pad worn far more than the outboard one points to binding slides or pins.

Example: a rotor has 26.0 mm cast into its hat as the minimum. After machining it measures 25.8 mm. The cast figure is the discard limit, not a machining target, so the rotor is replaced. Matching the other side to it would only make two thin rotors.

Check yourself

1. A customer reports a brake pedal pulsation with steering wheel shudder that happens only while braking. Which measurement most directly identifies the cause?

2. A single-piston floating caliper is found with the inboard pad worn much more than the outboard pad. Technician A says binding caliper slides or pins can cause this. Technician B says excessive rotor lateral runout is the usual cause. Who is right?

Facts checked 2026-11-15 · Sources: ASE: Official Automobile Study Guide (A5 Brakes test specifications and task list), ASE: Automobile and Light Truck (A1-A9) tests

ASE Automotive Technician cheat sheet: every key fact on one page →