Chapters0/30 ▾
Chapter 6 · Lesson 5 of 5
Wireless and voice quality problems
1 min read
In 2.4 GHz, an AP on channel 8 overlaps neighbors on 6 and 11, which corrupts frames rather than just making radios take turns. Move it to a clean channel in the 1, 6, 11 plan; raising power or widening to 40 MHz makes things worse.
On 5 GHz, if every client on one AP drops at once, returns about a minute later and the AP is now on a new channel with no authentication errors, the AP detected radar on a DFS channel and had to leave it.
The client decides when to roam. A handset that clings to a distant AP at a weak signal is a sticky client: tune the roaming threshold and enable fast roaming, rather than raising AP power or giving each AP its own SSID.
When throughput collapses but a Wi-Fi analyzer shows nothing wrong, the interferer may not be 802.11 at all, such as a microwave oven; only an RF spectrum analyzer sees raw energy in the band.
For voice, separate three measures. Latency is delay, loss is missing packets, and jitter is variation in arrival spacing. Choppy, robotic audio with steady 40 ms delay and 0.1% loss, but packets arriving anywhere from 5 to 80 ms apart, is a jitter problem; industry guidance targets jitter under about 30 ms. The fixes are a jitter buffer and QoS.
Check yourself
1. VoIP users report audio that sounds choppy and robotic although calls stay connected. Monitoring of the call path reports one-way delay steady at 40 ms, packet loss at 0.1 percent, and inter-packet arrival intervals varying between 5 ms and 80 ms. Which statement best describes the problem?
2. Warehouse staff using wireless VoIP handsets stay associated to the first AP they joined even after walking well past two other APs, with the handset reporting -82 dBm before the call finally drops. All APs share the same SSID and security settings, use different non-overlapping channels, and provide about 20 percent cell overlap. What is the best remedy?
Facts checked 2026-11-16 · Sources: CompTIA Network+ certification overview, RFC 3927: Dynamic Configuration of IPv4 Link-Local Addresses
CompTIA Network+ cheat sheet: every key fact on one page →