Chapters0/30 ▾
Chapter 2 · Lesson 5 of 5
VLANs, inter-VLAN routing and NAT
1 min read
An 802.1Q tag is 4 bytes inserted right after the source MAC address. It holds a priority field, a drop-eligible bit and a 12-bit VLAN ID. Twelve bits give 4,096 values, but 0 and 4095 are reserved, so usable VLANs are 1 to 4094, and the tag raises the maximum frame from 1,518 to 1,522 bytes.
On a trunk, the native VLAN is the one VLAN sent untagged. If the two ends disagree on the native VLAN, two broadcast domains merge, and double-tagging attacks abuse the same untagged behavior.
Each VLAN is its own subnet, and a Layer 2 switch never moves traffic between VLANs. To connect them you need a routed hop with a gateway address in each subnet: router-on-a-stick subinterfaces over a trunk, or an SVI on a multilayer switch.
NAT comes in several forms. Static NAT maps one inside address to one public address. Dynamic NAT leases public addresses from a pool. PAT, or NAT overload, lets hundreds of inside hosts share one public address by also rewriting source ports.
Port forwarding is destination NAT that publishes one inside service, such as TCP 443 on one server. NAT hides inside hosts only as a side effect; filtering still comes from a firewall or ACL.
Check yourself
1. About 200 internal hosts using RFC 1918 addresses share one public IPv4 address for outbound internet access, all at the same time. Which translation method makes that possible, and how does it work?
2. Which statement accurately describes IEEE 802.1Q VLAN tagging on an Ethernet frame?
Facts checked 2026-11-16 · Sources: CompTIA Network+ certification overview, RFC 1918: Address Allocation for Private Internets, RFC 4291: IP Version 6 Addressing Architecture
CompTIA Network+ cheat sheet: every key fact on one page →