Chapters0/30 ▾
Chapter 1 · Lesson 4 of 5
Wireless basics: channels, bonding, antennas and identifiers
1 min read
In 2.4 GHz the channel numbers are only 5 MHz apart, but each channel is about 20 MHz wide, so it spills over its neighbors. Channels must be five numbers apart to avoid overlap, which is why 1, 6 and 11 are the classic plan.
Channels 3 and 8, for example, are also clear of each other, but 6 and 8 overlap. Raising power never fixes overlap; it makes interference worse.
- Channel bonding joins two 20 MHz channels into 40 MHz: roughly double the throughput, but half as many free channels. It suits 5 GHz and 6 GHz, not crowded 2.4 GHz.
- 802.11n introduced MIMO and runs in both 2.4 GHz and 5 GHz. Downlink MU-MIMO arrived later with 802.11ac.
- The regulatory domain of the country, not the 802.11 amendment, decides which channels and power levels are allowed.
- Omnidirectional antennas cover an area; a directional dish or Yagi focuses gain into a narrow beam for a point-to-point bridge.
- The SSID (or ESSID when shared by many APs) is the network name; the BSSID is the MAC address of one AP radio.
Example: a dual-band AP advertising the SSID LAB shows two different BSSIDs, one per radio, while clients see a single network name and can roam between APs that share it.
Check yourself
1. In the 2.4 GHz band the 802.11 channel numbers are spaced 5 MHz apart, while a standard channel occupies about 20 MHz of spectrum. What does that arrangement mean for channel planning?
2. Several access points in one building all advertise the wireless network name CORP so that clients can roam between them. What identifies one individual access point radio inside that network?
Facts checked 2026-11-16 · Sources: CompTIA Network+ certification overview, RFC 1122: Requirements for Internet Hosts (TCP/IP layering)
CompTIA Network+ cheat sheet: every key fact on one page →