Chapters0/30 ▾
Chapter 1 · Lesson 3 of 5
Installing cable: plenum ratings and Power over Ethernet
1 min read
A plenum is a space, often above a drop ceiling, that returns air to the building's air handling system. Cable there must be plenum-rated (CMP), because a normal PVC jacket that burns would push smoke through the ventilation.
The rating is about fire safety, not speed: a plenum Category 6 cable performs exactly like a non-plenum Category 6 cable. Riser-rated (CMR) cable is the listing for vertical shafts between floors.
Power over Ethernet sends power and data on the same cable. The power source (PSE) is either an endspan, meaning the switch powers its own ports, or a midspan, meaning a separate injector placed in the cable run when the switch has no PoE.
Both use the same detection and classification with the powered device. Power rises with each amendment, so a camera or access point that needs more than the 802.3af level must be paired with a source that supports a later amendment.
| Standard | Approximate power at the PSE |
|---|---|
| 802.3af (PoE) | 15.4 W |
| 802.3at (PoE+) | 30 W |
| 802.3bt, all four pairs | Up to about 90 W |
Check yourself
1. Cable must be pulled through the space above a suspended ceiling that is used to return air to the building's air handling system. Why is plenum-rated (CMP) cable required there?
2. An access switch does not support Power over Ethernet, so a power injector is installed in the cable run between that switch port and a new wireless access point. What is this method of delivering power called?
Facts checked 2026-11-16 · Sources: CompTIA Network+ certification overview, RFC 1122: Requirements for Internet Hosts (TCP/IP layering)
CompTIA Network+ cheat sheet: every key fact on one page →