Chapters0/30 ▾
Chapter 2 · Lesson 2 of 5
Private, loopback and APIPA ranges, and traffic types
1 min read
| Range | Meaning |
|---|---|
| 10.0.0.0/8 | Private (RFC 1918) |
| 172.16.0.0/12 (172.16 to 172.31) | Private (RFC 1918) |
| 192.168.0.0/16 | Private (RFC 1918) |
| 127.0.0.0/8 | Loopback, never leaves the host |
| 169.254.0.0/16 | Link-local (APIPA), self-assigned when DHCP fails |
The middle private block stops at 172.31, so 172.31.9.9 is private but 172.32.9.9 is public. Private addresses need NAT to reach the internet. A host showing 169.254.x.x with mask 255.255.0.0 got no DHCP reply.
It can talk only to other self-assigned hosts on its own link. Typical causes are a stopped DHCP service, an exhausted pool, or a routed VLAN with no DHCP relay, since the DHCP DISCOVER is a broadcast that routers do not forward.
- Unicast: one sender to one interface.
- Multicast: one sender to the hosts that joined a group.
- Broadcast: one sender to every host on the local segment; it does not cross a router.
- Anycast: several servers share one address and routing delivers to the nearest one.
Check yourself
1. A workstation that normally uses DHCP shows the address 169.254.18.44 with the mask 255.255.0.0. It can reach a couple of other machines on the same switch, but not the default gateway or the internet. What is the most likely cause?
2. A content provider assigns the same IP address to servers in several cities, and the routing system delivers each client's packets to whichever of those servers is nearest along the best path. Which addressing and delivery type does this describe?
Facts checked 2026-11-16 · Sources: CompTIA Network+ certification overview, RFC 1918: Address Allocation for Private Internets, RFC 4291: IP Version 6 Addressing Architecture
CompTIA Network+ cheat sheet: every key fact on one page →