Chapters0/30 ▾
Chapter 2 · Lesson 1 of 5
IPv4 subnetting with the block-size method
1 min read
Every subnetting question can be solved with one routine. First find the interesting octet, the one where the mask is neither 255 nor 0. Subtract that mask value from 256 to get the block size.
Subnets start at multiples of the block size. The host's subnet is the multiple at or below its value, and the broadcast is one less than the next multiple.
Example: 172.16.40.150/27. A /27 mask is 255.255.255.224, so the block is 256 − 224 = 32 and subnets start at 0, 32, 64, 96, 128, 160. The value 150 sits in the 128 block, so the network is 172.16.40.128, the broadcast is 172.16.40.159, and the usable hosts run from .129 to .158, which is 30 addresses.
The same routine works on any octet: for 10.30.0.0/23 the mask is 255.255.254.0, the block is 2 in the third octet, and the broadcast is 10.30.1.255.
To size a subnet, use 2^h − 2 usable hosts, where h is the number of host bits, because the network and broadcast addresses cannot be assigned.
For 50 hosts, a /27 gives only 30, so the smallest fit is a /26 with 62. Two hosts are on the same subnet only if they fall in the same block, never just because their first three octets match.
Check yourself
1. A host is configured with the IPv4 address 192.168.20.77 and a /26 prefix. What is the network address of the subnet this host belongs to?
2. A network designer must place 100 devices on a single subnet and wants to waste as few addresses as possible. Which subnet mask is the smallest one that still fits the requirement?
Facts checked 2026-11-16 · Sources: CompTIA Network+ certification overview, RFC 1918: Address Allocation for Private Internets, RFC 4291: IP Version 6 Addressing Architecture
CompTIA Network+ cheat sheet: every key fact on one page →