Quibank app: now on the App Store — free, works offline. Get the app ↗

Chapters0/29 ▾
← Testing, Maintenance & Troubleshooting

Chapter 6 · Lesson 1 of 5

Taking a sample and reading chlorine

1 min read

A test only describes the water it came from, so take the sample from the water bathers are in: about elbow depth, in an area of good circulation, away from return inlets and skimmers.

Water right in front of a return reads the feeder's output and can hide a low residual in the far corners. Test right away, because chlorine breaks down in a warm, sunlit sample.

TestWhat it tells you
OTO (orthotolidine)Total chlorine only, as one yellow reading
DPD comparatorFree chlorine first, then total after another reagent
FAS-DPD titrationDrop count to an endpoint; readable at high levels and resolves small combined chlorine steps

Combined chlorine is always total minus free. Adding the two double-counts the free residual. If a DPD sample flashes pink and turns clear within seconds, very high chlorine has bleached the dye; that is not a zero reading.

Dilute the sample with chlorine-free water and multiply back. Example: 5 mL of pool water plus 20 mL of chlorine-free water makes 25 mL, a dilution factor of 5. A reading of 3.2 ppm means about 3.2 x 5 = 16 ppm in the pool.

Check yourself

1. After a heavy shock treatment the operator runs a DPD comparator test; the sample flashes pink and then turns clear within a few seconds. What is happening, and what is the right response?

2. An operator is drawing a routine chlorine and pH sample from a commercial pool. Which sampling method gives the most representative picture of the water the bathers are actually in?

Facts checked 2026-11-15 · Sources: CDC: Model Aquatic Health Code, 5th edition (2024), PHTA: Certified Pool/Spa Operator (CPO) certification

Pool Operator (CPO) cheat sheet: every key fact on one page →