Quibank app: now on the App Store — free, works offline. Get the app ↗

Chapters0/29 ▾
← Back

Study guide · Chapter 4 of 6

Pool Math & Calculations Study Guide — Pool Operator (CPO)

22 free practice questions

Pool math on the CPO exam covers volume, turnover and flow, filter area, chemical dosing, dilution and heating. Almost every wrong answer is a real number you get by skipping one step, such as forgetting to divide by 60 or to convert ounces to pounds, so the safest habit is to write every unit down. Turnover times and other legal targets come from the health code where the pool operates; the exam gives you the target and tests the arithmetic.

Key takeaways

  • Volume in gallons is length x width x average depth x 7.5, and a circle uses 3.14 x radius x radius.
  • Turnover in hours is gallons divided by gpm, then divided by 60.
  • Filtration rate is flow divided by filter area, and required area is flow divided by the rated rate.
  • A dose scales with volume divided by 10,000, times the ppm change, divided by the product's decimal strength.
  • After a partial drain, the new level is the share of old water kept times the old level, plus the share of fill water times its level.

Lessons in this chapter

5 short lessons · 5 min read

  1. 1Pool volume in gallons1 min
  2. 2Turnover time and flow rate1 min
  3. 3Filter area and filtration rate1 min
  4. 4Chemical dosing from a chart1 min
  5. 5Dilution, heating and spa water replacement1 min
View all questions & answers →

Facts checked 2026-11-15 · Sources: PHTA: Certified Pool/Spa Operator (CPO) certification, CDC: Model Aquatic Health Code, 5th edition (2024)

Pool Operator (CPO) cheat sheet: every key fact on one page →Next chapter: Facility Safety & Emergencies →

Practice questions based on the Pool & Hot Tub Alliance (PHTA) Pool & Spa Operator Handbook and public CDC healthy-swimming guidance. CPO and Certified Pool/Spa Operator are marks of the Pool & Hot Tub Alliance; this site is not affiliated with or endorsed by PHTA. Water-quality limits, turnover requirements and bather loads are set by the health code where your facility operates — always follow that code and your local health department, and confirm current course requirements before testing. About the CPO certification →