Chapters0/29 ▾
Chapter 3 · Lesson 3 of 5
Sand, cartridge and DE filters
1 min read
| Filter | How it is cleaned |
|---|---|
| High-rate sand | Backwash: flow is reversed up through the bed so grains lift, tumble and release dirt to waste |
| Cartridge | Shut down, relieve pressure, remove the elements and hose the pleats; soak if oils or scale blind them |
| Diatomaceous earth (DE) | Backwash, then feed a measured fresh DE slurry through the skimmer to precoat the grids |
In a DE filter the grids are only a support; the powder is the filtering surface, so running without a precoat lets dirt bind directly to the fabric and can permanently blind it. Backwashing a cartridge is the classic mix-up, and it only drives debris deeper into the pleats.
For sand, a correct backwash lifts the bed upward; pushing more water down through it would only drive dirt deeper and cause channeling and mudballs.
Filtration rate is flow per square foot of filter area, so required area equals flow divided by the rated maximum. Example: a pool that must be filtered at 360 gpm through a filter rated at 15 gpm per square foot needs at least 360 / 15 = 24 square feet.
Pushing water faster than the design rate lets finer particles through, hurts clarity and shortens runs between cleanings.
Check yourself
1. Immediately after a diatomaceous earth filter has been backwashed, what must the operator do before the system is back in normal service?
2. A commercial cartridge filter has reached its dirty differential. What is the correct servicing action?
Facts checked 2026-11-15 · Sources: PHTA: Certified Pool/Spa Operator (CPO) certification, CDC: Model Aquatic Health Code, 5th edition (2024)
Pool Operator (CPO) cheat sheet: every key fact on one page →