Quibank app: now on the App Store — free, works offline. Get the app ↗

Chapters0/29 ▾
← Testing, Maintenance & Troubleshooting

Chapter 6 · Lesson 3 of 5

Algae, dead spots and cleaning tools

1 min read

TypeHow it looks and behaves
GreenFree-floating; clouds and colors the whole body of water
Mustard (yellow)Powdery film on shaded walls; brushes off easily, then resettles
BlackDark raised spots rooted into plaster under a protective cap; regrows in the same spots

Black algae resists shock because its layered cap and roots shield the cells. Brushing tears that cap open so the oxidizer can reach underneath.

If algae keeps returning on one shaded wall while the morning test reads normal, the cause is usually a circulation dead spot that the measured chlorine never reaches; brushing and redirecting return inlets are part of the cure.

The DPD reagent does not read algae as chlorine, so blaming the test is the wrong turn. If the residual is fine everywhere and growth still lingers, check the cyanuric acid, since heavy stabilizer slows the kill.

Match the brush to the surface. Stainless bristles are for hard plaster only; vinyl liners and fiberglass get nylon and no abrasive pads, since a stainless brush can tear a liner.

After a heavy bloom, vacuuming to waste keeps debris out of the filter, but the pump keeps running, the level drops fast and must be topped up, and the fresh water dilutes chemistry, so retest afterward.

Check yourself

1. Black algae keeps coming back in the same spots on a plaster pool even after repeated shocking. Why does it resist treatment, and what does brushing accomplish?

2. An operator finds three growths in a plaster pool: a free-floating green cloud, a powdery yellow film on a shaded wall, and dark raised spots set into the plaster. Which identification is correct?

Facts checked 2026-11-15 · Sources: CDC: Model Aquatic Health Code, 5th edition (2024), PHTA: Certified Pool/Spa Operator (CPO) certification

Pool Operator (CPO) cheat sheet: every key fact on one page →