Quibank app: now on the App Store — free, works offline. Get the app ↗

Chapters0/29 ▾
← Testing, Maintenance & Troubleshooting

Chapter 6 · Lesson 5 of 5

Spa water care and winter closing

1 min read

A spa holds a small volume of warm water against a heavy bather load, so body oils, soaps, lotions and dissolved solids concentrate quickly.

Persistent foam whenever the jets run usually means low calcium hardness combined with those surfactants; the cure is to restore hardness and dilute or replace the water, with pre-swim showers for bathers. High calcium causes scale and cloudiness, not standing foam.

When a busy spa needs acid almost daily, its chlorine demand swings by the hour and dissolved solids keep climbing even with correct dosing, the water has reached the end of its useful life. Drain it, clean the shell and the filter, and refill. Recalibrating the feeder is good practice, but it cannot fix exhausted water.

In a hard-freeze climate, closing a pool is about trapped water, which expands as it freezes and splits pipes, pump housings and filter tanks. Lower the level below the returns, blow the lines clear, plug them and drain the equipment.

Leaving the system full and running works only until a power outage or pump failure, and one failed night in a hard freeze can crack the plumbing. Shocking the pool and leaving it untreated over winter misses the point, because the damage the procedure prevents is mechanical, not chemical.

Check yourself

1. A spa throws up a persistent head of foam whenever the jets run. Which combination of water conditions best explains it?

2. A busy spa needs acid almost daily, its chlorine demand swings from hour to hour, and dissolved solids keep climbing even though every chemical is dosed correctly. What does this pattern call for?

Facts checked 2026-11-15 · Sources: CDC: Model Aquatic Health Code, 5th edition (2024), PHTA: Certified Pool/Spa Operator (CPO) certification

Pool Operator (CPO) cheat sheet: every key fact on one page →