Chapters0/29 ▾
Chapter 3 · Lesson 2 of 5
Centrifugal pumps, head and cavitation
1 min read
A pool pump is a centrifugal pump. The spinning impeller throws water outward into the volute, which turns that speed into pressure, and the low pressure left at the impeller eye lets pool water push in behind it. It is not a positive displacement pump, so its flow is not fixed.
Total dynamic head is everything the pump works against: lift, pipe friction and fitting losses on the suction side plus the filter, heater, pipe and fitting losses on the discharge side, expressed in feet of head.
On a pump curve, more head always means less flow. A long run of undersized pipe raises head and slides the pump up its curve, so it moves less water with the same motor. The motor does not compensate by drawing more power; a centrifugal pump moving less water actually draws less.
Cavitation happens when suction pressure falls so low that water flashes to vapor at the impeller eye. The bubbles collapse on the vanes, the pump sounds like gravel passing through it, the vanes pit, and flow drops.
Bearing wear makes a steady whine instead and does not cut flow. A pump that runs but moves no water right after its strainer lid was opened most likely has an air leak at the lid O-ring and has lost prime.
Check yourself
1. A pump that has run quietly for years begins to rattle as though gravel were passing through it, and the flow meter reading has dropped. What is happening inside the pump?
2. How does the centrifugal pump on a pool recirculation system actually move water?
Facts checked 2026-11-15 · Sources: PHTA: Certified Pool/Spa Operator (CPO) certification, CDC: Model Aquatic Health Code, 5th edition (2024)
Pool Operator (CPO) cheat sheet: every key fact on one page →