Chapters0/29 ▾
Chapter 1 · Lesson 4 of 4
Calcium hardness, dissolved solids and the order of adjustments
1 min read
Calcium hardness is the calcium side of balance. Very soft fill water is calcium-hungry and will pull calcium out of plaster and grout, so the fix is to raise hardness with calcium chloride, not to add acid, which pushes the index further negative.
Use a calcium hardness test on the pool water itself: a utility's total hardness figure includes magnesium and overstates the calcium. Fresh plaster releases calcium hydroxide for weeks, which lifts pH and hardness, so a new surface needs the index held down on purpose.
- Calcium hypochlorite adds calcium with every dose, so in very hard water sodium hypochlorite, which adds none, is the better chlorine source, though it raises pH.
- Total dissolved solids only climb, because water evaporates and leaves chemicals and bather waste behind.
- Backwashing cannot lower dissolved solids; only replacing water with fresh water does.
- A heater coated in white scale while hardness and alkalinity both fall means calcium carbonate is leaving the water inside the hot exchanger.
When several readings are off on the same day, correct total alkalinity first, because it decides where pH settles. Adjust pH second, then calcium hardness, which moves neither of the others. Fixing pH first wastes chemical, since the next alkalinity correction moves the pH you just set.
Check yourself
1. A pool needs total alkalinity, pH and calcium hardness all corrected on the same service day. In what order should the operator work through them?
2. A pool refinished with fresh plaster shows pH climbing every day for weeks and a light film forming on the tile. What is behind that behavior?
Facts checked 2026-11-15 · Sources: PHTA: Certified Pool/Spa Operator (CPO) certification, CDC: Model Aquatic Health Code, 5th edition (2024)
Pool Operator (CPO) cheat sheet: every key fact on one page →