Quibank app: now on the App Store — free, works offline. Get the app ↗

Chapters0/29 ▾
← Pool Math & Calculations

Chapter 4 · Lesson 3 of 5

Filter area and filtration rate

1 min read

Filtration rate is the flow passing each square foot of filter surface, in gallons per minute per square foot. Divide flow by area.

Example: a sand filter with 15 square feet of surface passing 225 gpm runs at 225 / 15 = 15 gpm per square foot. The same relationship, turned around, sizes a filter: required area equals flow divided by the design rate the manufacturer allows.

  • Cartridge sizing: 300 gpm at a design rate of 0.375 gpm per square foot needs 300 / 0.375 = 800 square feet.
  • DE grids filter on both faces: 18 grids x 2.5 square feet per face x 2 faces = 90 square feet.
  • Sanity check: if a modest pool seems to need thousands of square feet of sand filter, you multiplied instead of dividing.

Count both faces of a DE grid only when the problem says water filters through both. Do not carry that habit over to a sand filter, where the area is the single surface of the bed.

Finally, check the direction of the fraction: area over flow gives a tiny decimal that is never a filtration rate. If your answer is a fraction of one gpm per square foot for a sand filter, or thousands of gpm per square foot, flip or re-check the division.

Check yourself

1. A cartridge filter bank must pass 375 gallons per minute, and the manufacturer's design filtration rate is 0.375 gallons per minute per square foot. How much filter surface area is required?

2. A high-rate sand filter with 12 square feet of filter surface area is passing 240 gallons per minute. What is the filtration rate?

Facts checked 2026-11-15 · Sources: PHTA: Certified Pool/Spa Operator (CPO) certification, CDC: Model Aquatic Health Code, 5th edition (2024)

Pool Operator (CPO) cheat sheet: every key fact on one page →