Quibank app: now on the App Store — free, works offline. Get the app ↗

Chapters0/29 ▾
← Disinfection & Sanitizers

Chapter 2 · Lesson 3 of 5

Cyanuric acid: sun protection with a cost

1 min read

Cyanuric acid, also called stabilizer, forms a weak, reversible bond with chlorine that shields it from ultraviolet light. Outdoors, that slows the daily loss of free chlorine in the sun. Indoors it buys nothing.

The trade-off is kill rate: at high stabilizer levels most of the residual is held in reserve, so the DPD test still reports normal free chlorine but very little hypochlorous acid is available at any moment, and germs die more slowly.

Stabilizer is not oxidized by shock, not caught by the filter and not used up in normal operation. Every stabilized product, such as trichlor tablets, adds more. The practical way to lower it is to drain part of the pool and refill with fresh water, then switch to an unstabilized chlorine so it does not climb right back.

Stabilizer also matters after a diarrheal incident: the CDC model code calls for draining to lower it to 15 ppm or less before the high-chlorine hold starts, or else secondary treatment or a full drain, before the pool can reopen.

  • CDC model code: cyanuric acid at or below 90 ppm in all aquatic venues.
  • It lists a cyanuric acid to free chlorine ratio above 45 to 1 as an imminent health hazard, and closes a venue at 300 ppm or higher.

Check yourself

1. A pool has run on trichlor tablets all season and now carries a very high stabilizer level. Free chlorine still tests in the facility's normal band, yet water quality complaints continue. What is the chemical explanation?

2. What does cyanuric acid do for an outdoor chlorinated pool?

Facts checked 2026-11-15 · Sources: CDC: Model Aquatic Health Code, 5th edition (2024), CDC: Operating and Managing Public Pools, Hot Tubs and Splash Pads, PHTA: Certified Pool/Spa Operator (CPO) certification

Pool Operator (CPO) cheat sheet: every key fact on one page →