Quibank app: now on the App Store — free, works offline. Get the app ↗

Chapters0/38 ▾
  1. 1.Safety, PPE, SCBA & Communications0/5
    1. Two-in/two-out and personnel accountability
    2. Maydays, emergency traffic and radio discipline
    3. Turnout gear: layers, inspection, retirement and decon
    4. SCBA readiness, air management and emergencies
    5. PASS devices and roadway scene safety
  2. 2.Fire Behavior & Building Construction0/5
    1. The fire tetrahedron, fuel properties and toxic smoke
    2. Heat transfer and reading smoke
    3. Ventilation-limited fires and hostile fire events
    4. Flow paths, closed doors and applying water
    5. Construction types and collapse hazards
  3. 3.Ground Ladders & Forcible Entry0/4
    1. Ladder parts, materials and service testing
    2. Climbing angle, tip placement and power lines
    3. Forcible entry tools and their care
    4. Forcing doors, locks, glass and roll-up gates
  4. 4.Search & Rescue and Ventilation0/4
    1. Primary and secondary search
    2. Moving victims, downed firefighters and VEIS
    3. Flow paths, door control and timing ventilation
    4. Horizontal, PPV, hydraulic and vertical ventilation
  5. 5.Water Supply, Hose, Streams & Extinguishers0/5
    1. Hydrants, water pressure and drafting
    2. Supply hose lays, hose loads and appliances
    3. Hose couplings, rolls and hose care
    4. Fire streams: nozzle pressure, steam and friction loss
    5. Portable extinguishers: classes, ratings and PASS
  6. 6.Fire Control, Overhaul, Ropes & Knots0/5
    1. Life safety rope, utility rope and rope care
    2. Knots and hoisting tools and hoselines
    3. Interior fire attack: direct, indirect and below-grade fires
    4. Vehicle, grass and flammable gas fires
    5. Property conservation and overhaul
  7. 7.Firefighter II Operations0/5
    1. Command and the Incident Command System
    2. Foam, flammable liquids and BLEVE prevention
    3. Sprinklers, standpipes and smoke alarms
    4. Fire cause, evidence and incident reports
    5. Airbag clearance, thermal imaging and hose testing
  8. 8.Hazmat Awareness & Operations0/5
    1. Response levels, training and a safe approach
    2. Placards, NFPA 704 and container shapes
    3. Using the Emergency Response Guidebook
    4. Product behavior, defensive control and public protection
    5. Control zones, decontamination and protection levels
Saved in this browser. Move it to another device →
← Safety, PPE, SCBA & Communications

Chapter 1 · Lesson 4 of 5

SCBA readiness, air management and emergencies

Varies by state. Your state sets this exam: the number of questions, time limit, pass mark and any state-law section can differ from this practice. Check your state's official handbook or licensing board before you test.

1 min read

At the start-of-shift check, IFSTA's Essentials of Fire Fighting (8th edition) and state skill sheets treat an SCBA as ready only when the cylinder holds at least 90 percent of its rated pressure.

Example: a 4,500 psi cylinder needs at least 4,050 psi; one reading 3,800 psi is swapped or refilled. Asking for exactly 100 percent is wrong because pressure changes with temperature.

  • Rule of Air Management: leave the IDLH atmosphere before the low-air alarm activates. This practice comes from NFPA 1404, which is now part of NFPA 1400 (2026 edition).
  • The 2013 edition of NFPA 1981 set the end-of-service-time alarm at 33 percent of rated pressure (25 percent was the older value). NFPA 1981 is now part of NFPA 1970 (2025), which sets the alarm by cylinder size, from 34 percent on a 2,216 psi cylinder to 29 percent on a 5,500 psi one (31 percent at 4,500 psi), so check the edition your SCBA is certified to.
  • If the regulator fails, open the bypass (purge) valve to get air, close it between breaths, and exit at once.
  • Composite cylinders have a service life set by their DOT or special permit label; a cylinder labeled for 15 years is retired at 15 years even if it just passed its hydrostatic test. Some newer designs carry a 30-year label, so read the label.

Check yourself

1. Under the Rule of Air Management, when should a firefighter working in an IDLH atmosphere leave the hazard area?

2. During the start-of-shift SCBA check, what is the minimum cylinder pressure, as a share of rated pressure, for the unit to be considered ready for service?

Facts checked 2026-11-15 · Sources: OSHA 29 CFR 1910.134: Respiratory Protection (two-in/two-out, paragraph (g)(4)), NFPA 1010: Professional Qualifications for Firefighters, NFPA 1850: Selection, Care and Maintenance of Protective Ensembles

Firefighter I & II Certification cheat sheet: every key fact on one page →