Chapters0/35 ▾
Chapter 5 · Lesson 2 of 5
Drive, boot and display symptoms
1 min read
Clicking or grinding from a spinning drive means the heads or actuator are failing, and every extra read or write makes it worse. With no current backup, image the drive to other media first, then replace it. Repair scans, defragmenting and repeated reboots all add heavy activity that can turn a partial loss into a total one.
A "no bootable device" message after a desktop was moved, with the drive missing from the firmware setup screen, most likely means a data or power cable worked loose. Reseat the cables and confirm the firmware detects the drive. Boot order only matters again once the drive is listed, and reinstalling the operating system would destroy data and still fail.
For RAID, V15 lists audible alarms, a missing array and a RAID failure. Read the controller's status screen or the drive LEDs to see which member failed before replacing anything, because pulling a healthy drive from a degraded array can take the whole array down.
An LCD makes no light of its own; it filters light from a backlight. If a laptop screen looks black but a flashlight held close shows a faint desktop, and an external monitor works, the panel, cable and graphics processor are fine. The backlight or its power circuit has failed.
Check yourself
1. After a desktop was moved to a new office, it powers on but displays a message that no bootable device or operating system was found. The firmware setup screen does not list the internal drive. What is the best next action?
2. A laptop's screen appears black, but when a bright flashlight is held close to it a faint image of the desktop is visible. An external monitor connected to the laptop displays normally. What is the most likely cause?
Facts checked 2026-11-15 · Sources: CompTIA A+ Core 1 (220-1201) V15 Exam Objectives, CompTIA A+ Core 2 (220-1202) V15 Exam Objectives, Microsoft Learn: Maximum tolerance for computer clock synchronization (Kerberos)
CompTIA A+ cheat sheet: every key fact on one page →