Chapters0/35 ▾
Chapter 1 · Lesson 2 of 5
Storage: M.2 drives and RAID levels
1 min read
An M.2 socket is defined by its keying and by the interface the board wired to it. Some sockets offer only SATA, so an NVMe module can fit and screw down yet never appear in firmware, because the socket supplies no PCIe lanes.
When a drive is invisible to both firmware and the operating system, think about the interface before any setting. A drive that clicks and reports a S.M.A.R.T. failure is dying: copy the data off first, then replace it. A long repair scan adds heavy reading and writing that can finish the drive off.
| Level | Method | Six 3 TB drives give | Survives |
|---|---|---|---|
| RAID 0 | Striping, no redundancy | 18 TB | No failures |
| RAID 5 | Striping with distributed parity | 15 TB | One drive |
| RAID 6 | Striping with two parity blocks | 12 TB | Two drives |
| RAID 10 | Stripe across mirrored pairs | 9 TB | One drive in any pair |
RAID 1 mirrors two drives. RAID 10 suits write-heavy work because it writes a duplicate with no parity math, while RAID 5 and 6 recompute parity on every write.
Check yourself
1. A small server has four 2 TB drives configured as a single RAID 5 array. What usable capacity does the array present, and what failure can it survive?
2. A technician fits an NVMe M.2 solid-state drive into a laptop's empty M.2 socket. The module seats and screws down normally, but neither the firmware nor the operating system shows any new drive. What is the most likely explanation?
Facts checked 2026-11-15 · Sources: CompTIA A+ Core 1 (220-1201) V15 Exam Objectives, CompTIA A+ certification overview, U.S. EPA: Used Lithium-Ion Batteries
CompTIA A+ cheat sheet: every key fact on one page →