Chapters0/35 ▾
Chapter 2 · Lesson 4 of 5
Wireless bands, cables and switches
1 min read
V15 lists three Wi-Fi frequencies: 2.4 GHz, 5 GHz and 6 GHz. Lower frequencies lose less energy passing through walls, so 2.4 GHz reaches farther indoors. Higher bands offer wider channels and more speed over shorter distances.
The 2.4 GHz band is also crowded and has only three non-overlapping channels in North America: 1, 6 and 11. A laptop two walls away that holds 2.4 GHz but drops 5 GHz is showing the range trade-off, not a power-saving setting.
- Copper twisted pair, shielded or not, is limited to 100 meters per run. Shielding helps near noise but does not extend that limit.
- Fiber carries light in glass, so it ignores electromagnetic noise from motors and welders and runs well past 100 meters. Multimode suits runs inside a site; single-mode goes much farther.
- A switch learns which MAC address sits behind each port and forwards a frame only to that port, which cuts collisions and raises throughput.
For example, a 250 meter run beside heavy motors rules out every copper choice twice: the noise and the distance. Fiber solves both at once.
Channel crowding is a real weakness of 2.4 GHz, but crowding does not change how far a signal penetrates walls. Answers that claim higher frequencies pass through walls better have the physics backwards.
Check yourself
1. A laptop two interior walls away from the access point holds a steady connection on the 2.4 GHz network but keeps dropping the 5 GHz one. What explains the difference?
2. A 250 meter link must cross a factory floor that runs beside large motors and welding equipment. Which cable should the technician specify?
Facts checked 2026-11-15 · Sources: CompTIA A+ Core 1 (220-1201) V15 Exam Objectives, CompTIA A+ certification overview, IETF RFC 1918: Address Allocation for Private Internets
CompTIA A+ cheat sheet: every key fact on one page →