Chapters0/35 ▾
Chapter 1 · Lesson 3 of 5
Motherboards, power supplies and cooling
1 min read
The board's form factor sets how many expansion slots fit along the rear edge. ATX is the full-size layout with up to seven slots, microATX shortens the board to at most four, and Mini-ITX has a single slot for compact builds. A build that needs five full-size cards therefore needs ATX. The chipset does not change the physical slot count.
Power supplies deliver 3.3 V, 5 V and 12 V outputs to the board through the 20+4 pin connector and others. The exam often makes you tell a power fault from a heat fault by timing.
A thermal shutdown follows sustained load, comes after the machine has warmed up, and shows high temperatures in firmware. A failing power supply cuts out at random, even seconds after a cold boot at idle with normal temperatures.
Heat leaves the processor only through the contact between the chip and the heat sink base.
If the processor overheats right after a cooler swap while the fan spins normally, lift the cooler, clean both surfaces, apply a thin fresh layer of thermal paste and reseat it evenly. A faster fan curve cannot help when heat is not reaching the fins.
Check yourself
1. A desktop switches off without warning at unpredictable moments, sometimes seconds after a cold boot while it sits idle. Firmware reports normal processor temperatures and the heat sink is clean. Which cause fits this pattern?
2. Right after a technician replaced a CPU cooler, the processor hits its thermal limit within a minute of any load, though the fan spins and case airflow is unchanged. What is the best next action?
Facts checked 2026-11-15 · Sources: CompTIA A+ Core 1 (220-1201) V15 Exam Objectives, CompTIA A+ certification overview, U.S. EPA: Used Lithium-Ion Batteries
CompTIA A+ cheat sheet: every key fact on one page →