Quibank app: now on the App Store — free, works offline. Get the app ↗

Chapters0/29 ▾
  1. 1.Hazards, Contamination & Allergens0/4
    1. TCS food, the danger zone and high-risk guests
    2. Infection, intoxication and the toxins cooking cannot fix
    3. Chemical hazards, physical hazards and food defense
    4. Food allergens and cross-contact
  2. 2.Personal Hygiene & Employee Health0/4
    1. What employees must report and what the person in charge owes
    2. Exclude or restrict: matching the response to the illness
    3. Handwashing: how, where and when
    4. Gloves, bare-hand contact, jewelry and work habits
  3. 3.Purchasing, Receiving & Storage0/4
    1. Approved sources and the records that prove them
    2. Receiving: temperatures, condition and rejection
    3. Storage: shelf order, location and chemicals
    4. Date marking and first in, first out
  4. 4.Preparation, Cooking & Cooling0/4
    1. Safe preparation and approved thawing methods
    2. Cooking temperatures and how to verify them
    3. Raw and undercooked food: advisories, parasites and high-risk guests
    4. Cooling and reheating cooked food
  5. 5.Holding & Service0/4
    1. Hot holding, cold holding and reheating
    2. Using time instead of temperature
    3. Serving food and handling tableware
    4. Buffets, catering and vending machines
  6. 6.Facilities, Sanitation & Pests0/5
    1. Cleaning versus sanitizing
    2. Proving that sanitizing works
    3. Water supply, backflow and drains
    4. Equipment, building surfaces and chemical storage
    5. Pest control and garbage
  7. 7.Management Systems, HACCP & Inspections0/4
    1. Active managerial control and the person in charge
    2. HACCP plans and prerequisite programs
    3. Emergencies, illness complaints and recalls
    4. Inspections and staff training
Saved in this browser. Move it to another device →
← Preparation, Cooking & Cooling

Chapter 4 · Lesson 4 of 4

Cooling and reheating cooked food

1 min read

Spore-forming bacteria survive cooking and grow fastest in the warm upper part of the danger zone, so cooling has two stages. Cooked TCS food must drop from 135°F to 70°F (57°C to 21°C) within 2 hours, and from 135°F to 41°F (5°C) or below within a total of 6 hours.

Example: chili is at 135°F at 1:00 pm. It must hit 70°F by 3:00 pm and 41°F by 7:00 pm. If it reaches 70°F at 2:30 pm, it still has until 7:00 pm, which leaves 4 hours 30 minutes.

Speed comes from more surface and less depth: shallow pans, smaller portions, an ice-water bath with stirring, ice as an ingredient, metal containers, food no more than 2 inches (5 cm) deep, or rapid-cooling equipment.

Pans are loosely covered, or left uncovered only where nothing can drip or fall in from above, and spaced so heat can escape. A deep, sealed bucket cools too slowly wherever it sits. If food misses the 2-hour checkpoint, the usual correction is to reheat it and start cooling again, or discard it.

Food cooked, cooled and reheated for hot holding must reach 165°F (74°C) for 15 seconds within 2 hours, using equipment that heats fast, not the steam table. Microwave reheating also reaches 165°F with a 2-minute covered stand.

Sealed, commercially processed ready-to-eat food needs only 135°F (57°C). A single portion reheated for a guest who just ordered it may be served at any temperature.

Check yourself

1. An operation's cooling procedure requires cooked chili to fall from 135°F (57°C) to 70°F (21°C) within 2 hours, then to 41°F (5°C) within a further 4 hours. Why does the first stage get its own tighter limit instead of one overall time limit?

2. A cook takes yesterday's braised beef from the cooler. One pan goes on the steam table for lunch service; a single portion is heated for a guest who has just ordered it. How do the two reheating requirements differ?

Facts checked 2026-11-15 · Sources: FDA Food Code 2026

Food Manager cheat sheet: every key fact on one page →