Quibank app: now on the App Store — free, works offline. Get the app ↗

Chapters0/29 ▾
  1. 1.Hazards, Contamination & Allergens0/4
    1. TCS food, the danger zone and high-risk guests
    2. Infection, intoxication and the toxins cooking cannot fix
    3. Chemical hazards, physical hazards and food defense
    4. Food allergens and cross-contact
  2. 2.Personal Hygiene & Employee Health0/4
    1. What employees must report and what the person in charge owes
    2. Exclude or restrict: matching the response to the illness
    3. Handwashing: how, where and when
    4. Gloves, bare-hand contact, jewelry and work habits
  3. 3.Purchasing, Receiving & Storage0/4
    1. Approved sources and the records that prove them
    2. Receiving: temperatures, condition and rejection
    3. Storage: shelf order, location and chemicals
    4. Date marking and first in, first out
  4. 4.Preparation, Cooking & Cooling0/4
    1. Safe preparation and approved thawing methods
    2. Cooking temperatures and how to verify them
    3. Raw and undercooked food: advisories, parasites and high-risk guests
    4. Cooling and reheating cooked food
  5. 5.Holding & Service0/4
    1. Hot holding, cold holding and reheating
    2. Using time instead of temperature
    3. Serving food and handling tableware
    4. Buffets, catering and vending machines
  6. 6.Facilities, Sanitation & Pests0/5
    1. Cleaning versus sanitizing
    2. Proving that sanitizing works
    3. Water supply, backflow and drains
    4. Equipment, building surfaces and chemical storage
    5. Pest control and garbage
  7. 7.Management Systems, HACCP & Inspections0/4
    1. Active managerial control and the person in charge
    2. HACCP plans and prerequisite programs
    3. Emergencies, illness complaints and recalls
    4. Inspections and staff training
Saved in this browser. Move it to another device →
← Facilities, Sanitation & Pests

Chapter 6 · Lesson 1 of 5

Cleaning versus sanitizing

1 min read

Cleaning removes food, grease and soil. Sanitizing reduces the germs left on a clean surface to a safe level. They are two separate steps and the order matters: sanitizer sprayed on a greasy table is tied up by the soil and shielded from the germs underneath, so it never does its job.

A single wipe with a sanitizer cloth is neither cleaning nor sanitizing. When the exam shows a cook spraying a dirty surface, the right response is to wash and rinse it, sanitize it, and retrain the cook on the order.

  • At a three-compartment sink: wash in detergent, rinse off the detergent, sanitize, then air dry.
  • The rinse step matters because detergent carried into the third sink weakens the sanitizer.
  • Towel drying can put germs back on a surface that was just sanitized, so items air dry.
  • In the 2026 model code, manual hot-water sanitizing means immersion in water of at least 171°F (77°C) for at least 30 seconds.

Food-contact surfaces in continuous use with TCS food are cleaned and sanitized at least every 4 hours under the model code, with longer intervals allowed only in specific cold conditions. Example: a slicer goes into use on deli meat at 6:45 a.m. It must be taken down, cleaned and sanitized by 10:45 a.m., even in the middle of a rush.

Check yourself

1. A manager is retraining staff on manual warewashing at the three-compartment sink. Which description of the process is correct?

2. A slicer has been used continuously on ready-to-eat deli meats since 9:00 a.m. and is still running at 1:30 p.m. The operation's procedure requires food-contact surfaces in continuous use with TCS food to be cleaned and sanitized at least every 4 hours. What should the manager do?

Facts checked 2026-11-15 · Sources: FDA Food Code 2026 (full text), FDA: Food Code

Food Manager cheat sheet: every key fact on one page →