Chapters0/45 ▾
- 1.Intake & Write-Up0/4
- 2.Status, Invoice & Delivery0/4
- 3.Complaints & Professional Conduct0/4
- 4.Estimates & Prioritised Recommendations0/4
- 5.Communicating Value & Objections0/4
- 6.Vehicle Systems & Components0/4
- 7.Maintenance Schedules & Procedures0/4
- 8.Warranty, Bulletins & Recalls0/4
- 9.Vehicle Identification0/4
- 10.Workflow, Scheduling & Sublet0/5
- 11.Internal Communication & Quality0/4
Chapter 6 · Lesson 3 of 4
Chassis, brakes, climate control and related items
1 min read
Springs carry the vehicle's weight and absorb bumps; shock absorbers damp the springs so the tire settles back on the road. In the brakes, the master cylinder turns pedal force into hydraulic pressure, the caliper clamps the pads, and the booster reduces pedal effort.
A tie rod links the steering gear to the knuckle and sets toe. Most late-model wheel bearings are sealed hub units replaced as an assembly, not repacked. In the air conditioning, the evaporator under the dash cools cabin air, the condenser in front of the radiator gives off the heat, and the compressor raises refrigerant pressure.
- Pads and rotors: caliper slides, pins, clips and shims come off with the pads, so hardware goes on the estimate.
- Tie rod or control arm: the alignment changes, so an alignment follows.
- New tires: the TPMS sensor service kit and, on many vehicles, a sensor relearn.
- Windshield with a forward camera: the driver-assistance camera must be calibrated through the new glass.
Check yourself
1. A steering estimate includes an outer tie rod end. What does a tie rod do, and what related work follows replacing one?
2. A brake estimate lists pads, rotors, a caliper and the master cylinder. How should the consultant describe what the master cylinder does?
Facts checked 2026-11-16 · Sources: ASE Automobile Service Consultant (C1) Study Guide 2026, ASE C1 Automobile Service Consultant test page
ASE C1 Service Consultant cheat sheet: every key fact on one page →