Chapters0/45 ▾
- 1.Intake & Write-Up0/4
- 2.Status, Invoice & Delivery0/4
- 3.Complaints & Professional Conduct0/4
- 4.Estimates & Prioritised Recommendations0/4
- 5.Communicating Value & Objections0/4
- 6.Vehicle Systems & Components0/4
- 7.Maintenance Schedules & Procedures0/4
- 8.Warranty, Bulletins & Recalls0/4
- 9.Vehicle Identification0/4
- 10.Workflow, Scheduling & Sublet0/5
- 11.Internal Communication & Quality0/4
Chapter 4 · Lesson 2 of 4
Presenting findings with evidence
1 min read
Present each finding with the measurement and the specification it is compared against, and say which items are safety related and which can be scheduled. That lets the customer decide for themselves.
An item above minimum is reported honestly as serviceable rather than sold today, and it is not left out either, because the customer plans around knowing the work is coming.
Example: rear pads measure 6 mm against a 3 mm minimum. You give her both numbers, tell her the brakes are fine for now, and say the pads will need attention at a future visit.
Two exceptions are raised immediately even if the customer is in a hurry: a do-not-drive condition such as a bulge in a tire sidewall, which can fail without warning, and a safety item already at its limit, such as tread worn to the wear indicator.
Check findings against the service history before they reach the customer. If the sheet recommends a filter the shop replaced 900 miles ago, resolve it with the technician first. Attribute findings to the technician honestly: if asked whether you saw a leak, say the technician found it on the lift and offer to have it shown.
Softening a real finding to avoid an awkward question is as wrong as overselling. If the leak is real, say so and stand behind the technician's report.
Check yourself
1. An inspection reports front brake pads at 5 mm against a 3 mm minimum, with rotors within specification. The customer asks whether she should have the brakes done today. How should the consultant answer?
2. An inspection turns in four findings on a customer's vehicle: - A rear tire has a bulge in the sidewall - Front brake pads measure 4 mm against a 3 mm minimum - The serpentine belt shows fine cracks across the ribs - Washer fluid is low Which finding must be presented as unsafe to drive rather than as work the customer may schedule later?
Facts checked 2026-11-16 · Sources: ASE Automobile Service Consultant (C1) Study Guide 2026, ASE C1 Automobile Service Consultant test page
ASE C1 Service Consultant cheat sheet: every key fact on one page →