Chapters0/45 ▾
- 1.Intake & Write-Up0/4
- 2.Status, Invoice & Delivery0/4
- 3.Complaints & Professional Conduct0/4
- 4.Estimates & Prioritised Recommendations0/4
- 5.Communicating Value & Objections0/4
- 6.Vehicle Systems & Components0/4
- 7.Maintenance Schedules & Procedures0/4
- 8.Warranty, Bulletins & Recalls0/4
- 9.Vehicle Identification0/4
- 10.Workflow, Scheduling & Sublet0/5
- 11.Internal Communication & Quality0/4
Chapter 11 · Lesson 2 of 4
Diagnosis, the three Cs and declined work
1 min read
The consultant's job is translation, not diagnosis, and translation requires understanding the finding first. If you do not understand why a repair is needed, go over it with the technician before you call the customer, not while the customer is on hold. Then record it in the three Cs.
| Entry | What it holds | Example |
|---|---|---|
| Concern | The customer's own description | Headlights dim at idle at night |
| Cause | The condition the technician found that produced it | Alternator output below specification |
| Correction | The work actually performed | Replaced alternator, verified output |
The cause is the link between the complaint and the work; without it the order shows a part replaced for no stated reason. Declined recommendations are written on the customer's invoice with the date and odometer reading and carried forward to the next visit. That record shows the condition was found and reported, and that the customer chose to wait.
It does not move cost to a warranty or let the shop refuse later service. Many inspection standards split findings into required service, for a part that no longer works, measures out of specification or is missing, and suggested service, for scheduled maintenance or wear that has not yet failed a measurement.
On a test item, a measurement below the manufacturer's discard limit is required, while early wear with no failed measurement is suggested; presenting the two as equal, in either direction, misrepresents the vehicle.
Check yourself
1. A customer reports the temperature gauge reading high in slow traffic. The technician finds the cooling fan motor inoperative and replaces it. On the repair order, "cooling fan motor inoperative" belongs in which entry?
2. An inspection reports two findings on one vehicle: - Front brake rotor measured 0.030 in. below the manufacturer's discard thickness - Serpentine belt shows light surface cracking, no missing chunks and no glazing How should these two be presented to the customer?
Facts checked 2026-11-16 · Sources: ASE Automobile Service Consultant (C1) Study Guide 2026, ASE C1 Automobile Service Consultant test page
ASE C1 Service Consultant cheat sheet: every key fact on one page →